Installation, 1 closing the door, 1 positioning – AEG A42200GSW0 User Manual
Page 27
Problem
Possible cause
Solution
Large quantities of food
to be frozen were put in
at the same time
Insert smaller quantities of
food to be frozen at any
one time.
Food placed in the appli-
ance was too warm
Allow food to cool to room
temperature before stor-
ing.
Products to be frozen are
placed too closely to
each other
Place the products in a way
so that cold air could circu-
late among them
It is too cold inside
the freezer
Temperature regulator
may be set incorrectly
Set a warmer temperature
The appliance does
not work at all. Nei-
ther cooling nor
lighting works
Plug is not connected to
the mains socket properly
Connect the mains plug
properly
Power does not reach the
appliance
Try connecting another
electrical device to the
power outlet
The appliance is not
switched on
Switch on the appliance
There is no voltage in the
mains socket (try to con-
nect another appliance
into it)
Call an electrician
The appliance does
not cool at all
Plug is not connected to
the mains socket properly
Connect the mains plug
properly
There is no voltage in the
mains socket (try to con-
nect another appliance
into it)
Call an electrician
The appliance is not
switched on
Switch on the appliance
8.1 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
This appliance should be installed in a
dry, well ventilated indoor where the am-
bient temperature corresponds to the
ENGLISH
27