AEG SRP 4335 CD-MP3 - Manual (Page 41)

English
41
Press five times: the function is deactivated and the CD is
played in the normal mode.
Folder selection only for MP3 CDs:
To navigate one folder up press and hold the button dur-
ing playback. F 01 will flash on the display. Press SKIP
DOWN/ SKIP UP to select the desired folder. CD playback
starts automatically. The reading in the display will also blink
when pressing and holding this button during stop mode.
Press the
PLAY/PAUSE button to start playback.
Programmed Play
This can be used to program any desired sequence of tracks.
1. Press the STOP/USB/CARD button (16).
2. Press the PROGRAM button (18). The number “P01”
(storage location) and the symbol PROG flash in the dis-
play. Use the SKIP DOWN/ SKIP UP buttons (21/20)
to select the desired track and then press the PROGRAM
button again. The display changes to memory slot P02.
3. Select the next track with the SKIP DOWN/ SKIP UP
button and press the PROGRAM button again. Repeat
the procedure until all the desired tracks are selected.
NOTE:
• Once the storage capacity of the tracks to be pro-
grammed has been reached, “FUL” flashes in the
display.
• Press the PROGRAM button to show the pro-
grammed tracks.
4. Press the PLAY/PAUSE button (25). The playback
starts. The selected track numbers are shown in the
display in the correct order and the symbol or MP3
and PROG. light up. Press this button to pause briefly the
playback.
5. Press once the STOP/USB/CARD button (16) to stop
the playback while retaining the program.
6. To resume the playback of the program press first the
PROGRAM button once and then the PLAY/PAUSE.
7. Press the STOP/USB/CARD button twice to delete the
program. The PROG icon on the display turns off.
The device stops automatically once the entire sequence of
programmed tracks is completed. The programmed order of
tracks remains in the memory until you change to a different
mode, remove the CD from the CD compartment or switch
off the device.
Playing back Music in MP3 Format
With this device it is possible to play back pieces of music in
MP3 format. The device also supports all standard CD types:
CD, CD-RW, CD-R.
This machine of is able to play MP3 CDs. Up to 200 tracks
can be compressed and stored on these CDs. Your machine
detects an MP3 CD automatically (the total number of
tracksand MP3s appears in the display). If you would like to
play one of these CDs, proceed as described under “Playing
CDs/MP3”. Tracks can be programmed as described under
“Programmed Play”.
Please note:
There are a number of different recording and compression
methods, as well as quality differences between CDs and
selfrecorded CDs.
Furthermore, the music industry does not adhere to fixed
standards (copy protection).
For these reasons it is possible that in rare cases there are
problems with the playback of CDs and MP3 CDs. This is
not
a malfunction of the device.
Cleaning and Maintenance
• Always remove the mains plug before cleaning the
machine.
• Any marks on the surface can be wiped off with a slightly
damp cloth without any additives.
NOTE: Compact Disks:
• This device is able to play CDs with a diameter of 8 cm
and 12 cm.
NOTE:
Only place one disc in the CD compartment at a
time.
• Only audio CDs, CD-R and CD-RW disks can be played
on this machine.
• Always place the CD into the CD compartment with
the label facing upwards. Compact discs can only be
played on one side.
• Fingerprints and dust should be carefully removed from
the recorded side of the CD (the side without the label)
with a soft cloth. Wipe off in straight lines from the
centre to the edge.
• After being played, CDs should be returned to their
case so that they do not become scratched.
• Do not expose CDs to direct sunlight, high humid-
ity levels or prolonged high temperatures in order to
prevent them from warping.
• Do not adhere any paper to the CD or write on it.
• Do not spray any cleaning agents or antistatic sprays on
to the CD as in the case of phonographs.