Allstar Products Group ANSI/UL 325 - Manual (Page 28)

28
Manufacturer’s Limited Warranty
Allstar warrants its gate operators to be free from defect in material and workmanship for a period of five (5) years from the date of purchase
for single family home use and three (3) years from the date of purchase for multi-family and commercial use. This warranty covers all
components except the electronic circuit boards which are warranted for three (3) years from the date of purchase for single family home use
and two (2) years from the date of purchase for multi-family and commercial use. To obtain service contact your dealer.
To obtain service under this warranty the buyer must obtain authorization instructions for the return of any goods from Allstar before
returning the goods. The goods must be returned with complete identification, with copy of proof-of-purchase, freight prepaid and in
accordance with Allstar’s instructions or they will not be accepted. In no event will Allstar be responsible for goods returned without proper
authorization or identification.
Goods returned to Allstar for warranty repair within the warranty period, which upon receipt by Allstar are confirmed to be defective and
covered by this limited warranty, will be repaired or replaced at Allstar’s sole option, at no cost and returned pre-paid. Defective parts will
be repaired or replaced with new or factory rebuilt parts at Allstar’s sole option.
This limited warranty does not cover non-defect damage, damage caused by unreasonable use, damage caused by improper installation or
care, vandalism or lightning, fire or excessive heat, flood or other acts of God (including, but not limited to misuse, abuse or alterations,
failure to provide reasonable and necessary maintenance), labor charges for dismantling or reinstalling a repaired or replaced unit, or
replacement batteries.
These warranties are in lieu of all other warranties, either expressed or implied. All implied warranties of merchantability and/or fitness for a
particular purpose are hereby disclaimed and excluded. Under no circumstances shall Allstar be liable for consequential, incidental or
special damages arising in connection with the use or inability to use this product. In no event shall Allstar’s liability for breach of warranty,
breach of contract, negligence or strict liability exceed the cost of the product covered hereby. No person is authorized to assume for Allstar
any other liability in connection with the sale of this product.
This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Warranty effective after May
15th, 1997.
c.p. Allstar Corporation
Downingtown, PA 19335
This Gate Operator is built in the USA and
complies with all requirements of
Underwriters' Laboratories Standard UL-325.
P/N 110135 Rev. D December 2003
PHYSICAL
PAD: 24W x 30D x 3H
OVERHEAD CLEARANCE: 21 Inch Minimum
UNIT SIZE: 16-1/8 x 24-7/8 x 17-1/4
FRAME: Welded steel, Coated to UL Standards
COVER: Molded Polyethylene
SHIPPING WEIGHT: 150 lbs.
PRIMARY VOLTAGE: 115 VAC, 60 Hz
ELECTRICAL SOURCE: One 3-Wire 15 AMP Service per
CONTROL VOLTAGE: 12/24 VDC
RADIO RECEIVER
POWER:
24 VAC
MOTOR: 1/2 HP, 4.4 AMP PSC, Instant Reversing
ELECTRICAL
DRIVE
DRIVE SYSTEM: 60:1 Gearbox
TORQUE LIMITER: Mounted on Output Shaft,
OUTPUT SHAFT: 1-1/4 Diameter Ball-Bearing Mounted
LIMITS: Independent Open & Close; Displaced
Cam with Micro Switch
MAX. GATE WEIGHT: 1000 lbs.
MAX. GATE WIDTH: 18 Feet
MAX. CYCLES PER HOUR: 60 Open/Close per Hour
1200 Open/Close per Day
GATE SPEED: 13-15 Seconds for 90º Opening
CAPACITIES
Specifications subject to change without notice. Consult the factory.
TECHNICAL SPECIFICATIONS