AEG HK953400FB - Manual (Page 13)

Problem Possible cause Remedy
The highest heat setting
is set. The highest heat setting
has the same power as
the Automatic Heat Up
function.
The heat setting changes
between two levels. The Power management
is activated. Refer to “Power manage-
ment”.
The sensor fields be-
come hot. The cookware is too
large or you put it too
near to the controls. Put large cookware on
the rear cooking zones if
necessary.
comes on. The Automatic Switch
Off operates. Deactivate the appliance
and activate it again.
comes on. The Child Safety Device
or the Lock function op-
erates. Refer to the chapter
“Daily Use”.
comes on. No cookware is on the
cooking zone. Put cookware on the
cooking zone.
The cookware is incor-
rect. Use the correct cook-
ware.
The diameter of the bot-
tom of the cookware is
too small for the cook-
ing zone. Move cookware to a
smaller cooking zone.
and a number come
on.
There is an error in the
appliance. Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If
comes on again,
speak to the service cen-
tre.
comes on. There is an error in the
appliance because a
cookware boils dry. The
overheating protection
for the cooking zones
and the Automatic
Switch Off operate. Deactivate the appliance.
Remove the hot cook-
ware. After, approximate-
ly 30 seconds, activate
the cooking zone again.
If the cookware was the
problem, the error mes-
sage goes out of the dis-
play, but the residual
heat indicator can stay.
Let the cookware be-
come sufficiently cool
and refer to “Cookware
for the induction cooking
zone” to see if your cook-
ware is compatible with
the appliance.
ENGLISH
13