AEG HK614010MB - Manual (Page 9)

Problem Possible cause Remedy
Residual heat indicator does
not come on. The zone is not hot because
it operated only for a short
time. If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
You cannot activate the out-
er ring. Activate the inner ring first.
There is a dark area on
the multiple zone.
It is normal that there is a
dark area on the multiple
zone.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
8. INSTALLATION
WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Serial number ...........................
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
8.3 Connection cable
• For a single phase or two phase
connection use the following (or
higher) mains cable type: H05BB-F
Tmax 90°C.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05BB-F Tmax 90°C.
Speak to your local Service Centre.
ENGLISH 9