AEG HK654200FB - Manual (Page 8)

• the hob gets too hot (e.g. when a saucepan boils dry). Before you use the hob again, the
cooking zone must be cool.
• you use incorrect cookware. comes on and after 2 minutes the cooking zone stops
automatically.
• you do not stop a cooking zone or change the heat setting. After some time comes
on and the hob stops. See the table.
Automatic Switch Off times
Heat setting - - - -
Stops after 6 hours 5 hours 4 hours 1.5 hours
The heat setting
Touch the control bar at the heat setting. Change
to the left or the right, if it is necessary. Do not
release before you have a correct heat setting. The
display shows the heat setting.
Automatic Heat Up
1
2
3
4
5
6
7
8
9
10
11
12
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14
You can get a necessary heat setting in a shorter time if you activate the Automatic Heat
Up function. This function sets the highest heat setting for some time (see the graphic), and
then decreases to the necessary heat setting.
To start the Automatic Heat Up function for a cooking zone:
1. Touch ( comes on in the display).
2. Immediately touche the necessary heat setting. After 3 seconds comes on in the dis-
play.
To stop the function change the heat setting.
Switching on and off the power function
The power function gives more power to an induction cooking zone for no longer than 10
minutes. After that time, the induction cooking zone automatically sets back to . To
start it , touch and comes on. To stop it, set a heat setting between and .
P
8 Operating instructions