AEG Battery Charger LP 10.0 - Manual (Page 28)

28
B B
A
C C
M. If the charger is connected to the battery
but unable to detect a voltage the display will be
blank. You may then try manually starting the
charging process by pressing the emergency
mode button . If the battery voltage then rises
to above 3.5 V within a few minutes, charging
will continue normally. If the voltage remains
below this level charging will be suspended and
the display will read . You may now discon-
nect the charger from the battery and reconnect it
to rule out the error being caused by the
equipment being incorrectly connected to the
battery (also refer to Item 1.4
“ Quick guide for
connecting and disconnecting the charger “ on
page 20!)
Attention!
If the battery is intact charging will start
once the battery voltage has been detected.
(go to step 7, page 30!) .
Figures C - L on pages 24 and 25 indicate the
normal charging process!
If the battery is defective or deep discharged
or other errors occur the display will show the
following depending on the battery state:
Display
M, N, O, P, Q, R, S, T - see pages
28 - 30!
Step 6: Battery detection mode and
possible error messages
C.
During this charging phase the battery voltage
is being detected. This detection mode may take
a few minutes. The display will read and one
individual segment of the digits 00 will also be
turning.
Step 5: Stand by
B. Now plug the mains plug into a suitable
230 V alternating current outlet. The display will
read . The charger is ready for use.
A. If the polarity of the charging clamps is
reversed the supply current to the battery will be
inter-rupted. The display will read . The
symbol will flash.
Step 4: Correct polarity
Verify the two charging clamps are well
connected with the correct battery terminals.
Clean off any residue on battery terminals.
Caution - risk of electrical shock!
Step 3: Connect black clamp
Now connect the negative (-) black charging
clamp to the negative (-) battery terminal. A minus
sign (-) must be visible near the battery terminal.
Step 2: Connect red clamp
First connect the positive (+) red clamp to the
positive (+) battery terminal. A plus sign (+) must
be visible near the battery terminal.
Step 1: Preparation
Do not yet connect the charger to a 230 V
alternating current outlet! Ensure the room and
battery surroundings are well ventilated!
4.1 Start charging
4.0 OPERATION
9
C
A
M
5
6
B
0
5
25
75
95
100
97100_Ladeger t _LP_10.0 Manual _09_12_2011_print
Freitag, 9. Dezember 2011 11:11:31