AEG T76485AH User Manual
Page 24
Problem
1)
Possible cause
Remedy
Abnormally
elapsing
time on the
display.
)
The time to end is calculated on
the basis of the volume and
dampness of the laundry.
The automatic procedure — this
is not the appliance malfunction.
Programme
inactive.
The water container is full.
Drain the water container
3)
,
push the Start/Pause button.
Drying cycle
too short.
Too small laundry volume.
Do the selection of time pro-
gramme.
The laundry is too dry.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Drying cycle
too long
6)
The filter is clogged.
Clean the filter.
Too high volume of the load.
Obey the maximum load vol-
ume.
The laundry not spun sufficient-
ly.
Spin correctly the laundry.
Very high room temperature -
this is not the appliance mal-
function.
If possible, lower the room tem-
perature.
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on.
Make a selection of the new programme. Push the Start/Pause button. Does not operate? -
contact the service centre and give the error code.
2) follow the programme description — see PROGRAMMES chapter
3) see CARE AND CLEANING chapter
4) see section WATER HARDNESS in HINTS AND TIPS chapter
5) Only the tumble dryers with drum light.
6) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).
24