AEG HK634060XB - Manual (Page 6)

• A qualified electrician must install the clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains cable of type H05BB-F Tmax 90°C (or higher) for a single-phase.
• Replace the damaged mains cable with a special cable (type H05BB-F Tmax 90°C; or
higher). Speak your local Service Force Centre.
The appliance must have the electrical installation which lets you disconnect the appliance
from the mains at all poles with a contact opening width of minimum 3 mm.
You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips and contactors.
If, you use the accessory frame C-FRAME, first read the instruction supplied with the frame
before you install the appliance.
Assembly
min.
50mm
min.
50mm
min.
500mm
=
=
340 +1 mm
600mm
490 +1 mm
R 5mm
min.
25 mm
min.
20 mm
6 Installation instructions