AEG F55200VI0 - Manual (Page 12)

Electronic adjustment
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to ‘SETTING AND
STARTING A PROGRAMME’.
3. Press and hold Delay and Start at the
same time until the indicators (A), (B)
and (C) flash.
4. Press Program.
• The indicators (B) and (C) go off.
• The indicator (A) continues to flash.
• The display shows the setting of the
water softener. Example: = lev-
el 5.
5. Press Program again and again to
change the setting.
6. Deactivate the appliance to confirm.
FILLING THE SALT CONTAINER
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt contain-
er (only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it, af-
ter you fill the salt container, start
a programme.
FILLING THE RINSE AID DISPENSER
M AX
1 2 3
4 + -
A B
D
C
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between po-
sition 1 (lowest quantity) and posi-
tion 4 (highest quantity).
12 www.aeg.com