AEG A72710GNW0 - Manual (Page 11)

Problem Possible cause Solution
There is no voltage in the
mains socket (try to con-
nect another appliance
into it) Call an electrician
The appliance does
not cool at all Plug is not connected to
the mains socket properly Connect the mains plug
properly
There is no voltage in the
mains socket (try to con-
nect another appliance
into it) Call an electrician
The appliance is not
switched on Switch on the appliance
A rectangular sym-
bol is shown on the
right side of the
Temperature Display Temperature sensor
problem Call the service personnel
7.1 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
8. TECHNICAL DATA
Dimension
Height 850 mm
Width 595 mm
Depth 635 mm
Rising Time 13 h
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.
ENGLISH
11