Avanti RM1702PS - Manual (Page 3)

3
IMPORTANT SAFEGUIDES
Before the refrigerator is used, it must be properly positioned and installed as
describe d in this manual,so read the manual carefully. To reduce the risk of fire,
electrical shock or injury when using the refrigerator, follow basic precaution,
including the following:
?
Plug into a grounded 3 -prong outlet, do not remove grounding prong, do not use an ad apter, and
do not use an extension cord.
?
It is recommended that a separate circuit, serving only your refrigerator be provided. Use
receptacles that cannot be turned off by a switch or pull chain.
?
Never clean refrigerator parts with flammable fluids. These fumes can create a fire hazard o r
explosion. And do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance. The fumes can create a fire hazard or explosion.
?
Before proceeding with cleaning and maintenance operations, make sure the power line of the
unit is disconnected.
?
Do not connect or disconnect the electric plug when your hands are wet.
?
Unplug the refrigerator or disconnect power before cleaning or servicing. Failure to do so can
result in electrical shock or death.
?
Do not attempt to repair or replace any part of your refrigerator unless it is specifically
recommended in this manual. All other servicing should be referred to a qualified technician.
FOLLOW WARNING CALL OUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL
?
Use two or more people to move and install refrigerator. Failure to do so can result in back or
other injury.
?
To ensure proper ventilation for your refrigerator, the front of the unit must be completely
unobstructed. Choose a well -ventilated area with temperatu res above 6 0°F (16
°
C) and below
90°F (32°C). This unit must be installed in an area protected from the element, such as wind, rain,
water spray or drips.
?
The refrigerator should not be located next to ovens, grills or other sources of high heat.
?
The refrigerator must be installed with all electrical, water and drain connections in accordance
with state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly
grounded in accordance with the National Electrical Code and local codes and ordinances is
required.
?
Do not kink or pinch the power supply cord of refrigerator.
?
The fuse (or circuit breaker) size should be 15 amperes.
?
It is important for the refrigerator to be leveled in order to work properly. You may need to make
several adjustments to level it.
?
All installation must be in accordance with local plumbing code requirements.
?
Make certain that the pipes are not pinched or kinked or damaged during installations .
?
Check for leaks after connection.
?
Never allow children to operate, play with or crawl inside the refrigerator.
?
If you use the drainage container , you must set the drain select switch to OFF or the water can
overflow from the drainage container
?
Although the unit has been tested at the fa ctory, due to long-term transit and storage, the first
batch of cubes must be discarded.
?
Do not use solvent-based cleaning agents of abrasives on the interior. These cleaners may
damage or discolor the interior.
?
Do not use this apparatus for other than its intended purpose.