AEG HK854320FB - Manual (Page 8)

DAILY USE
ACTIVATION AND
DEACTIVATION
Touch for 1 second to activate or de-
activate the appliance.
AUTOMATIC SWITCH OFF
The function deactivates the appliance
automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before you
use the appliance again, wait for the
cooking zone to cool down.
• You use incorrect cookware. The sym-
bol comes on and the cooking zone
deactivates automatically after 2 mi-
nutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
comes on and the appliance
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
, - — 6 hours
•
- — 5 hours
• - — 4 hours
•
- — 1.5 hours
THE HEAT SETTING
Touch the control bar at the heat setting.
Change up or down, if it is necessary. Do
not release before you have a correct heat
setting.
BRIDGE FUNCTION
The Bridge function connects two cook-
ing zones and they operate as one.
First set the heat setting for one of the
cooking zone.
To activate the Bridge function for left/
right cooking zones touch
/ . To set
or change the heat setting touch one of
the left/right control sensors.
To deactivate the Bridge function touch
/ . The cooking zones operate inde-
pendently.
AUTOMATIC HEAT UP
You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see
the diagram), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch ( comes on in the dis-
play).
2. Immediately touch the necessary heat
setting. After 3 seconds
comes on
in the display.
To stop the function change the heat set-
ting.
8 www.aeg.com