AEG SCS51810S0 - Manual (Page 6)

2.3 Switching off the
appliance
1. Keep ON/OFF switch pressed for
more than 5 seconds.
2. A countdown on the temperature in-
dicators, from -3 -2 -1 will be shown.
When “1” appears the appliance is
turned off. The temperature indica-
tors switch off. The Pilot lights switch
off.
2.4 High temperature alarm
In the event of an abnormal temperature
rise inside the freezer (e.g. power cut)
alarm indicator light will start to flash
and a buzzer will sound.
Push the alarm reset button to stop the
buzzer sound, while the alarm indicator
light will continue to flash.
The buzzer will stop automatically when
the temperature has returned to normal
while the alarm indicator light will contin-
ue to flash.
Press the alarm reset button. The alarm
indicator light goes out and at the same
time the freezer temperature indicator
show for about 5 seconds the warmest
temperature reached in the freezer com-
partment.
2.5 Temperature setting
buttons
The temperature is adjusted using the
temperature setting buttons. These but-
tons are connected to the temperature
indicator.
• Each time one of the two buttons is
pressed again the temperature is ad-
justed by 1°C. The set temperature
will be reached within 24 hours.
2.6 Temperature indicators
The temperature indicators show several
information:
• During normal operation, the temper-
ature currently set for fridge and freez-
er are displayed.
• When the temperature is being adjus-
ted a flashing display indicates the
fridge/freezer temperature currently
set.
2.7 Temperature regulation
To operate the appliance, proceed as
follows:
1. Set the required temperature by
pressing the corresponding temper-
ature regulator. The temperature in-
dicator will immediately show the
changed setting and the tempera-
ture indicator flashes.
2. Each time the temperature regulator
is pressed the temperature is adjus-
ted by 1 °C. The set temperature will
be reached within 24 hours.
3. The temperature indicator will
change from flashing to continuous
illumination.
For a correct storage of the food the fol-
lowing temperatures should be set:
• +5 °C in the fridge
• -18 °C in the freezer.
When the setting is changed, the
compressor does not start imme-
diately if automatic defrosting is
currently taking place. As the
storage temperature within the
fridge is reached quickly you can
store food immediately after
switching on.
2.8 DYNAMICAIR function
To switch on the function:
1. Press the DYNAMICAIR button.
2. The DYNAMICAIR indicator is
shown.
To switch off the function:
1. Press the DYNAMICAIR button.
2. The DYNAMICAIR indicator goes
off.
If the function is activated auto-
matically the DYNAMICAIR indi-
cator is not shown (refer to "Daily
use").
The activation of the DYNAMI-
CAIR function increases the ener-
gy consumption.
2.9 COOLMATIC function
The COOLMATIC function is suitable for
quick cooling of large quantities of
goods in the refrigerator.
To activate the function, do these steps:
6 www.aeg.com