AEG A5200AZ - Manual (Page 10)

PROBLEM POSSIBLE CAUSES SOLUTION
Motor will not start or suddenly stops Unit not connected to power source • Push plug securely into outlet
• Try another outlet or check circuit breaker
• Check plug and cord for damage
Switch not turned on •
Themal cut-off has operated • Correct the cause of motor overheating. See thermal cut-off information
No suction.
Vacuum cleaner does not pick up lint or dirt Blockage in air path •
clean out areas #1 & #2
Dust cup full • Empty dust cup
Dust Cup Filter clogged •
if dust cup does not look full
Hepa Filter clogged •
Dust Cup Filter not in place •
•
-
Switch not on proper setting •
•
-
sories
* Turbo nozzle clogged (selected models only) • Remove and clean debris from turbo nozzle
Dust cup will not lock into vacuum cleaner Dust Cup Filter not in place •
Quick Release handle will not lock into
vacuum cleaner
Telescopic wand is extended • Place end of wand into opening at back of vacuum and align ribs into
grooves
Red “check brush roll” indicator light is on Object caught in brush roll • Unplug vacuum, remove debris and threads from brush roll. Depress
brush roll reset button, plug in unit, and continue.
•
• Check brush roll for threads and debris. Clean if needed
Brush roll not positioned properly • Make sure both ends of brush roll are free of debris and secured properly
so roll can rotate freely
Brush roll not operating properly
Note: ”Check brush roll” indicator light turns
on when brush roll is not turning. Brush roll
motor will shut off to prevent damage to motor.
Brushroll will not turn Using brushroll clean pedal on high pile rug/carpet •
TROUBLESHOOTING
For your safety, turn vacuum cleaner off and unplug power cord before
attempting to resolve problems.
Note: Any servicing of the vacuum other than described in this manual shall only be performed by an authorized service representative.
C
M
Y
CM
MY
CY
CMY
K