AEG F77012M0P - Manual (Page 14)

Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
SETTING AND STARTING A
PROGRAMME
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• All the phase indicators come on.
• The time of the last set programme
flashes in the display.
If the control panel shows other condi-
tions, press and hold Multitab and De-
lay at the same time until the appliance
is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance.
3. Close the appliance door.
4. Make sure that the appliance is in
setting mode.
5. Turn the programme knob until the
marker on the knob is aligned with
the programme you want to set.
• The programme duration flashes
in the display.
• The phase indicators of the set
programme come on.
6. Press Start. The programme starts.
• Only the indicator of the phase in
operation stays on.
• The display shows the pro-
gramme duration that decreases
with steps of 1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until
the display shows the delay time
you want to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
3. Press Start. The countdown starts.
• The display shows the countdown
of the delay start that decreases
with steps of 1 hour.
• The phase indicators of the set
programme go off.
• When the countdown is completed,
the programme starts.
– The indicator of the phase in oper-
ation comes on.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the
appliance continues from the point of
interruption.
Cancelling the delay start while
the countdown operates
Press Delay again and again until:
• The display shows the programme
duration.
• The phase indicators come on.
• The programme starts.
Cancelling the programme
Press and hold Multitab and Delay at
the same time until:
• The programme duration flashes in
the display.
• The phase indicators come on.
14