AEG F99009M0P - Manual (Page 12)

7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when all the programme indica-
tors come on and the display shows 2
horizontal status bars. If the control pan-
el does not show this condition, press
and hold, at the same time Delay and
Start until the appliance is in setting
mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Close the appliance door.
4. Press Program again and again until
the indicator of the programme you
want to set comes on. You can also
set the applicable options.
• The duration of the programme
flashes in the display.
• The indicators of the phases that
are foreseen for the programme
come on.
5. Press Start to start the programme.
• When the programme starts, only
the indicator of the running phase
stays on.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The Delay indicator comes on.
• The delay time flashes in the dis-
play.
• The indicators of the phases that
are foreseen for the programme
go off.
3. Press Start to start the countdown.
• The countdown starts to decrease
with steps of 1 hour.
When the countdown is completed, the
programme starts. The indicator of the
running phase comes on.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press and hold, at the same time, De-
lay and Start until all the programme
indicators come on and the display
shows 2 horizontal status bars.
2. Set the programme again.
Cancelling the programme
1. Press and hold, at the same time, De-
lay and Start until all the programme
indicators come on and the display
shows 2 horizontal status bars.
Make sure that there is detergent
in the detergent dispenser be-
fore you start a new programme.
At the end of the programme
The display shows 0 and the end indica-
tor comes on.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off
button, the Auto Off function au-
tomatically deactivates the appli-
ance a few minutes after the end
of the programme.
This helps to decrease the ener-
gy consumption,
12 www.aeg.com