AEG Multi-Powerpack ML 12 - Manual (Page 23)

GB 23
5. unplug the 230 V mains plug (11) from the mains socket or the car plug (10)
from the 12 V car outlet and roll up the cable neatly.
Mobile device charging process
▪
Verify the Multi Power Pack is fully charged.
▪
the Multi Power Pack will automatically switch off after 20 seconds when not in
use. the display will turn off.
1. Select an adapter (14, 16) to fit your mobile device and plug it into the connec-
ting cable (12 or 15).
2. connect the Multi Power Pack to the devices to be charged using the connecting
cable
3. Press the activation button (6). charging will start. the display shows the battery
capacity of the Multi Power Pack in percent.
Note: recharge the Multi Power Pack (see “Multi Power Pack charging process”),
once the information disappears from the display (1).
4. Disconnect the Multi Power Pack from the device after charging (note display on
the connected device).
Switching the light on/off
the Multi Power Pack features an leD light (9) with various lighting options.
Warning!
risk of injury! Do not look directly into the light or shine into others’ eyes as this
may damage the retina.
▪
Switching on/off: Press the activation button for approx. 2 seconds (6). the leD
will light steady.
▪
Flashing light: Pressing the activation button again once switched on.
▪
SoS: Press the activation button 2x once switched on.
▪
Switching off: Press the activation button (6) for approx. 2 seconds or press the
activation button 3x once switched on.
the light may also be used whilst charging a mobile device.