AEG L87490FL - Manual (Page 26)

12. TROUBLESHOOTING
The start of the appliance does not oc-
cur or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
service centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Problem Possible cause Possible solution
The appliance
does not fill with
water. The water tap is closed. Open the water tap.
The water inlet hose is
damaged. Make sure that the water inlet
hose has no damages.
The filters in the water
inlet hose is blocked . Clean the filters. Refer to 'Care
and cleaning'.
The water tap is blocked
or is furred with lime-
scale. Clean the water tap.
The connection of the
water inlet hose is not
correct. Make sure that the connection
is correct.
The water pressure is
too low. Contact your local water author-
ity.
The appliance
does not drain the
water. The water drain hose is
damaged. Make sure that the water drain
hose has no damages.
The filter of the drain
pump is blocked. Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
The connection of the
water drain hose is not
correct. Make sure that the connection
is correct.
A washing programme
without the drain phase
is set. Set the drain programme.
The function Rinse &
Hold is on. Set the drain programme.
The appliance
door is open or
not closed cor-
rectly. Close the door correctly.
26 www.aeg.com