AEG L61470WDBI - Manual (Page 18)

5. Press button 4 to start the pro-
gramme. The indicator of button 4
is on.
The drain pump can operate for
a short time when the appliance
fills water.
The appliance adjust auto-
matically the cycle time to the
laundry you have put in the
drum to have perfect washing
results in the minimum neces-
sary time. After approximate-
ly 15 minutes from the start of
the programme, the display
shows the new time value.
9.4 Interrupt a programme
1. Press button 4 . The indicator
flashes.
2. Press button 4 again. The washing
programme continues.
9.5 Cancel a programme
1. Press button 1 to cancel the pro-
gramme and to deactivate the appli-
ance.
2. Press button 1 again to activate
the appliance. Now, you can set a
new washing programme.
The appliance does not drain the
water.
9.6 Change a function
You can change only some functions be-
fore they operate.
1. Press button 4 . The indicator
flashes.
2. Change the function set.
9.7 Set the delay start
1. Press button 5 again and again un-
til the display shows the number of
minutes or hours. The related sym-
bols comes on.
2. Press button 4 , the appliance
starts the countdown of the delay
start.
When the countdown is completed,
the programme starts automatically.
Before you press button 4 to
start the appliance, you can can-
cel or change the set of the delay
start.
You cannot set the delay start
with the Steam programme.
9.8 Cancel the delay start
1. Press button 4 . The related indica-
tor flashes.
2. Press button 5 again and again un-
til the display shows 0’.
3. Press button 4 . The programme
starts.
9.9 Open the door
While a programme or the delay start
operates, the appliance door is locked.
To open the appliance door:
1. Press button 4 . The door lock
symbol in the display goes off.
2. Open the appliance door.
3. Close the appliance door and press
button
4 . The programme or the
delay start continues.
If the temperature and level of
the water in the drum are too
high, the door lock symbol stays
on and you cannot open the
door. To open the door do the
steps that follow:
1. Deactivate the appliance.
2. Wait for some minutes.
3. Make sure that no water is in
the drum.
If you deactivate the appliance, it
is necessary to set the pro-
gramme again.
9.10 At the end of the
programme
• The appliance stops automatically.
• The acoustic signals operate.
• In the display comes on.
• The indicator of the Start/Pause but-
ton 4 goes off.
18 www.aeg.com