AEG US 900 XE - Manual (Page 10)

8
GB
English
WARNING! Read all safety warnings and all instruc-
tions, including those given in the accompanying brochure.
Failure to follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS
Wear ear protectors. Exposure to noise can cause hearing loss.
Hold power tool by insulated gripping surfaces, when perfor-
ming an operation where the cutting accessory may contact
hidden wiring or its own cord. Cutting accessory contacting a
„live“ wire may make exposed metal parts of the power tool „live“
and could give the operator an electric shock.
Appliances used at many different locations including open air should
be connected via a residual current device (FI, RCD, PRCD) of 30mA
or less.
Always wear goggles when using the machine. It is recommended to
wear gloves, sturdy non slipping shoes and apron.
The dust produced when using this tool may be harmful to health. Do
not inhale the dust. Wear a suitable dust protection mask.
Sawdust and splinters must not be removed while the machine is
running.
Before doing any work on the machine, pull the plug out of the
socket.
Only plug-in when machine is switched off.
Keep mains lead clear from working range of the machine. Always
lead the cable away behind you.
Always use the protective shields on the machine.
Do not use cracked or distorted saw blades.
Plunge cuts without pre-drilling a hole are possible with soft
materials (wood, light building materials for walls). Harder materials
(metals) must first be drilled with a hole corresponding to the size of
the saw blade.
When working in walls ceiling, or floor, take care to avoid electric
cables and gas or waterpipes.
SPECIFIED CONDITIONS OF USE
This sabre cut is intended to cut wood, plastic, and metal. It can cut
straight lines, curves, and internal cut-outs. It cuts pipes and can cut
flush to a surface.
Do not use this product in any other way as stated for normal use.
TECHNICAL DATA
Reciprocating Saw
US 900 XE
Production code 4196 21 01...
4196 11 01...
... 000001-999999
Rated input 900 W
Stroke rate under no-load 0-3500 min -1
Lengths of stroke 19 mm
Weight according EPTA-Procedure 01/2003 2,9 kg
Noise/Vibration Information
Measured values determined according to EN 60 745.
Typically, the A-weighted noise levels of the tool are:
Sound pressure level (K=3dB(A))
Sound power level (K=3dB(A))
Wear ear protectors!
89,5 dB(A)
100,5 dB(A)
Total vibration values (vector sum in the three axes) determined according to EN 60745.
Cutting boards
Vibration emission value a
h, B
Uncertainty K=
18,3 m/s 2
1,5 m/s 2
Cutting wooden beams
Vibration emission value a
h, WB
Uncertainty K=
20,0 m/s 2
1,5 m/s 2
WARNING
The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and
may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with
different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running
but not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.