Addonics Technologies DVD R/RW - Manual (Page 8)

Chapter 4
Using the DVD±R/RW DigiCopier as a Stand Alone
DVD±R/RW Copier
# Connect the power cable to the back of the DVD DigiCopier.
# Plug in the Power Cord to the AC Power Source
(+90~+250VAC)
# Set the switch (S1 on figure 1, page 6) at the back to Duplicator
position. Then turn the power on at the front to start the DVD
DigiCopier as a Stand Alone DVD Copier
# LED Display will now lit at the front, will do a series of check, will
check Firmware version. Once the initiation is completed (about
10 -15 seconds), the Power light will stay lit.
# You are now ready to use the DVD±R/RW DigiCopier.
# Insert a source DVD or CD on the top DVDROM Drive,
# Insert a Blank DVD±R, DVD±RW, CD-R or CD-RW Disc at the
Bottom DVD±R/RW drive
# Close the Tray and that’s it.
# Once the copy is done, the bottom tray will open and you may
now use the created Disc.
Note: The duplication time depends on the amount of data on the source
and the type of media in the destination drive. A full 680MB CD takes
approximately 6 – 7 minutes to copy onto a 16X certified CD-R. A full
Addonics Technologies – DVD±R/RW DigiCopier Users Guide v1.0 7