Using the cycle print mode, Using the cycle print mode -34 – Konica Minolta MSP3500 User Manual
Page 66
2-34
Scann
er
Ch
ap
te
r 2
18. Using the Cycle Print Mode
This function automatically scans the next image following a preset period of time. Images
are manually loaded onto the Carrier Glass in between cycles.
This is a system setting that must be entered by an authorized dealer.
If you want to use the Cycle Print Mode, ask your Tech. Rep. to make the necessary system
setting. Then you can perform the following operations.
NOTE
This function is only available on the PR mode.
Specifying the interval between scanning operations
1
Press the Multi-Print Key to change the value to “A”. This enables the Cycle Print
Mode. Press the Multi-Print Key to set the interval of time between scan operations.
(Refer to the diagram below).
Memory Input Key
2
Press the Memory Input key to store the currently selected interval setting of the Cycle
Print Mode into the memory.
Value
1
2
3
4
5
6
7
8
9
0
Period (sec.)
0.5
1.0
1.5
2.0
2.5
3.0
3.5
4.0
4.5
5.0