Asus Leonite P5LP-LE User Manual
Page 9
A S U S P 5 L P - L E ( L e o n i t e )
A S U S P 5 L P - L E ( L e o n i t e )
A S U S P 5 L P - L E ( L e o n i t e )
A S U S P 5 L P - L E ( L e o n i t e )
A S U S P 5 L P - L E ( L e o n i t e )
5
5
5
5
5
3.
System memory
The motherboard comes with four Double Data Rate 2 (DDR2) Dual Inline
Memory Module (DIMM) sockets.
A DDR2 module has the same physical dimensions as a DDR DIMM but has a
240-pin footprint compared to the 184-pin DDR DIMM. DDR2 DIMMs are
notched differently to prevent installation on a DDR DIMM socket.
The following figure illustrates the location of the DDR2 DIMM sockets.
3 . 1
3 . 1
3 . 1
3 . 1
3 . 1
Memory configurations
Memory configurations
Memory configurations
Memory configurations
Memory configurations
You can install 256 MB, 512 MB, and 1 GB DDR2 SDRAM DIMMs into the
DIMM sockets using the memory configurations in this section.
•
Installing DDR2 DIMMs other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of
the recommended configurations on the next page.
•
Install only i d e n t i c a l
i d e n t i c a l
i d e n t i c a l
i d e n t i c a l
i d e n t i c a l (the same type and size) DDR2 DIMM pairs
using the recommended configurations.
•
Make sure that the memory frequency matches the CPU FSB (Front
Side Bus). Refer to the Memory frequency/CPU FSB synchronization
table on the next page.
•
This motherboard does not support double-sided 16-bit DDR DIMMs.
•
Do not create a three-DIMM configuration in dual-channel mode. The
third DIMM is ignored in the dual-channel operation.
P5LP-LE
P5LP-LE (Leonite) 240-pin DDR2 DIMM sockets
XMM1
XMM2
XMM3
XMM4