Ariston DB62 - Manual (Page 29)

29
GB
● Take particular care not to damage the inner surface
of the door inner glass that is coated with a heat
reflective layer.
! Do not use scouring pads, or abrasive cleaners /
powder, which will scratch the glass. Ensure that the
glass panel is not subjected to any sharp mechanical
blows.
Stubborn stains can be removed by using a fine steel
wool pad. For slight soiling the inner glass panel may
be cleaned, while still warm, without removing it from
the door. After cleaning, rinse and dry with a soft cloth.
Side opening doors
Cleaning the door glass is the same as the drop down
doors, except take care to support the weight of the
inner glass when removing and refitting.
Drop down doors
Remove the door inner glass as follows:
1. Open the door fully and unscrew the two screws
securing the glass panel so that the securing
brackets can be turned. There is no need to
remove the screws completely.
2. Turn the brackets so that the
glass can be removed and
cleaned at the sink.
3. The inside of the outer door
glass can now be cleaned
while still fitted to the cooker.
! Never operate the cooker without the inner door
glass in position.
Refit the door inner glass as follows:
1. NOTE: The inner door glass has a special
reflective coating on one side. Replace the door
inner glass so that the statement: “IMPORTANT
THIS FACE TOWARDS THE OVEN” can be read
from the inner side of the door.
2. Turn the two securing brackets
back to their original position
to retain the glass and tighten
the screws.
Switching off the electricity
! Turn off the mains switch before cleaning it and
during all maintenance operations.
● Before switching on again, ensure that all controls
are in the OFF position.
Cleaning the oven doors
Oven door removal (Main Oven)
The door is removable to facilitate occasional cleaning
of heavy soiling from the oven floor and from the door
itself.
● Please note that the door is heavy and care should
be taken not to pinch your fingers during the
removal and replacement.
To remove
1.
Open the door fully and, using a coin or
screwdriver, turn the two discs clockwise.
2. Slightly close the door, unhook the lower hinge
fingers, then pull the door away from the oven
front frame.
To replace
1.
Insert the lower fingers and the hooked ends of
the door stays, ensuring that the slots in the lower
fingers engage with the front frame.
2. Fully open the door and turn the discs anti-
clockwise to their normal working positions. Close
the door - the hinge will now lock into position.