Avanti DW18 - Manual (Page 16)

16
glassware. much detergent.
Too high inlet water temperature. prevent this from happening, use less
detergent if you have soft water. Wash
glassware in the shortest cycle that will get
them clean.
Make sure inlet water temperature is correct.
Yellow or brown film
on inside surfaces. Tea or coffee stains.
Iron deposits in water can cause an
overall film. Using a solution of ½ cup bleach and 3 cups
warm water to remove the stains by hand.
Warning: Before cleaning interior wait at
least 20 minutes after a cycle for the heating
elements to cool down. Failure to do so can
result in burns.
A special filter in the water supply line is the
only way to correct this problem. Contact a
water softener company for a special filter.
White film on inside
surfaces. Hard water minerals. To clean the interior, apply dishwasher
detergent to a damp sponge. Wear rubber
gloves. Do NOT use any other cleaner than
dishwasher detergent for the risk of foaming
or suds.
Detergent left in
dispenser cups. Dishes block detergent cups. Re-load the dishes properly.
Steam This is normal. Steam comes through the vent during
washing, drying and when water is being
pumped out.
Black or gray marks
on dishes. Aluminum utensils have rubbed
against dishes. Remove marks with a mild, abrasive cleaner.
Water standing in the
bottom of the tub. This is normal. A small amount of clean water around the
outlet on the tub bottom at the back of the tub
keeps the water seal lubricated.
Water doesn’t pump
out of the tub. Drain is clogged. If you have an air gap, clean it.
Make sure the kitchen sink is draining well.
If the dishwasher drains into a disposer, run it
clear.
Dishwasher leaks. Overfill dispenser or rinse aid spills.
Dishwasher isn’t level. Be careful not to overfill the rinse aid
dispenser. Spilled rinse aid could cause
oversudsing and lead to overflowing. Wipe
away any spills with a damp cloth.
Make sure the dishwasher is level.
Spots and filming on
glasses and flatware Extremely hard water
Low inlet water temperature
Overloading the dishwasher
Improper loading
Old or damp powder detergent
Rinse agent dispenser empty
Too little detergent To remove stubborn spots and pre-existing
film from glassware:
1. Remove all metal utensils from the
dishwasher.
2. Do not add detergent.
3. Choose the HEAVY cycles.
4. Start the dishwasher and allow to run for
30 minutes. Dishwasher will now be in
the main wash.
5. Open the door and pour 2 cups (500ml)
of white vinegar into the bottom of the
dishwasher.
6. Close the door and allow to complete the
cycle. If vinegar rinse doesn’t work: