Actron 9640 - Manual (Page 96)

Ford Historic Self-Test Routines
6 – 16 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
6
After all codes are sent, the series will repeat once and then stop. An example
is shown below.
If necessary, refer to an appropriate vehicle service manual for procedure on
how to use STAR Test Mode for specific vehicle under test.
When done, press
BACK to return to the Ford Function List.
Code Lookup
Code Lookup is used to look up definitions of Diagnostic Trouble Codes
(DTCs) stored in the scan tool. The scan tool does not require power from the
vehicle to perform this function. Internal battery power can be used.
Select Code Lookup from the Ford
Function List .
Only one character can be changed at
a time.
❒ Use LEFT/RIGHT arrow keys to
position the cursor.
❒ Use the UP/DOWN arrow keys to
change the selected character.
A Three-Digit DTC (214) will Flash as follows:
STO: LOW-LOW =2XX (Hundreds Place =2)
STO: HIGH Short Pause
STO: LOW =21X (Tens Place =1)
STO: HIGH Short Pause
STO: LOW-LOW-LOW-LOW =214 (Ones Place =4)
Two-Digit DTCs (12, 42) will Flash as follows:
STO: LOW =1X (Tens Place =1)
STO: HIGH Short Pause
STO: LOW-LOW =12 (One’s Place =2)
STO: HIGH Long Pause (Between DTCs)
STO: LOW-LOW-LOW-LOW =4X (Tens Place =4)
STO: HIGH Short Pause
STO: LOW-LOW =42 (Ones Place =2)
Ford Function List ?
11)Print Data ]
` 12)Code Lookup [
13)Manual Info ~
Lookup Code: 000
Use Arrow Keys ^
To Select Or Press
ENTER To Lookup
~
Lookup Code: 058
Use Arrow Keys ^
To Select Or Press
ENTER To Lookup
~