AT&T E5811 - Manual (Page 3)

Telephone base installation
NOTES:
1. Use only the power adapter supplied with this product or equivalent.
To order a replace-
ment power adapter, visit our website at www.telephones.att.com
or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL), and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
6 . You may be able to make
or receive short calls. For
best performance, place the
handset in the telephone
base to charge for at least
16 hours before first use.
Telephone line cord
DSL filter
(Optional for DSL users, see
number four in the note
section, below.)
5. Plug the other end of the telephone
line cord into a telephone jack.
4. Plug the large end of the
larger power adapter into
an electrical outlet not con-
trolled by a wall switch.
3. Route cords through
slots.
1. Plug the small end of the larger
power adapter into the power jack at
the bottom of the telephone base.
2. Plug the end of the telephone line
cord into the telephone jack at the
bot tom of the telephone base.