Lenovo L215p Wide Flat Panel Monitor - Manual (Page 8)

1-4
L215p Wide Flat Panel Monitor User’s Guide
Setting up your monitor
This section provides information on how to set up your monitor.
Connecting and turning on your monitor
1. Power off your computer and all attached devices, and unplug the computer
power cord.
2. Connect the analog signal cable to the video port on the back of the computer.
Note: One end of the signal cable is already pre-attached to your monitor.
Place the cable into the specific hook indicated in below figure.
3. Connect the HDMI cable to the HDMI connector of the monitor and the other end
on the back of the computer.
Place the cable into the specific hook indicated in below figure.
4. Connect the USB cable to the upstream USB port of the back of the monitor and
the other end to an appropriate USB port on your computer