Lenovo H520g Desktop - Manual (Page 95)

Figure 27. Removing the primary hard disk drive
6. Slide the new hard disk drive into the hard disk drive bay and align the screw holes in the new hard
disk drive with the corresponding holes in the drive bay. Then, install the four screws to secure the
new hard disk drive in place.
Figure 28. Installing the hard disk drive
7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an
available SATA connector on the system board. See “Locating parts on the system board” on page 68.
Then, locate an available five-wire power connector and connect it to the rear of the new hard disk drive.
Chapter 9 . Replacing FRUs 91