Lenovo H500s Desktop User Manual

Page 45

Text mode
Original mode

Step 3.

Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to “Left and right view”
and “Rear view” for help with locating the various connectors.

Step 4.

Remove the computer cover. Refer to “Removing the computer cover”.

Step 5.

Remove the microprocessor fan. Refer to “Replacing the microprocessor fan”.

Step 6.

Remove the heat-sink. Refer to “Replacing the heat-sink”.

Step 7.

To remove the microprocessor

from the system board, press then slide the small handle out

to spring it up.

and open the retainer.

Attention: Do not touch the gold contacts on the bottom of the microprocessor. When handing the
microprocessor, touch only the sides.

Note: Do not drop anything onto the microprocessor socket while it is exposed. The socket pins must
be kept as clean as possible.

Chapter 8

Replacing hardware