Kodak ZD710 - Manual (Page 60)

54 www.kodak.com/go/support
Troubleshooting
Picture quality problems
If Try one or more of the following
Picture is too dark ■ Reposition camera for more available light.
■ Use Fill flash ( see page 9 ) or change your position so light is not
behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range (
see page 9 ).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■ If using P, A, or S mode, adjust exposure compensation ( see
page 37 ).
Picture is too light ■ Reposition camera to reduce the amount of available light.
■ Turn flash off ( see page 9 ).
■ Move so that the distance between you and the subject is within the
effective flash range (
see page 9 ).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■ If using P, A, or S mode, adjust exposure compensation ( see
page 37 ).
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■ Clean the lens ( see page 60 ).
■ Make sure camera is not in Close-up/Macro mode if you are more
than 27.6 in. (70 cm) from your subject. (Move further away if you
are using the zoom lens in Close-up/Macro.)
■ Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.