Kodak Other Chargers User Manual

Kodak usb power pack kp1850, User guide, Operation

KODAK USB Power Pack

KP1850

User Guide

The KP1850 is a rechargeable Li-Ion power pack ideal for

charging and powering MP3 players, cell phones, digital

cameras, and portable gaming systems via a USB cable.
Approximate additional run/talk time (results vary by

device):
• MP3 players

≤ 60 hours

• Cell phones

≤ 9 hours

• Smart phones

≤ 4.5 hours

Operation

1. Charge the KP1850 before ﬁrst use. To charge, plug it

into a power outlet. Charging takes up to 5 hours.

Note: Maximum cycle life is obtained by shallow

discharge and charge conditions; bring to a full charge

regularly.

2. Connect the

included micro USB

to USB cable to

both the KP1850

and your USB

device. You can

connect a second

device using the

cable that came

with the device.

IMPORTANT:

For APPLE mobile digital devices, use the USB cable that

came with your device.

Unplug the cable(s) when not in use to conserve power in

the KP1850.

Specifications

Voltage

100-240 V, 50/60 Hz

Input Current

100 mA maximum

Output Current

1000 mA maximum

USB Output

5 V + 0.35 V; -0.0 V

Storage

-4 to 86° F (-20 to 30° C)

Operation

32 to 113° F (0 to 45° C)

Battery

3.7V 1850mAh 6.85Wh

IMPORTANT SAFETY

INSTRUCTIONS—Save These Instructions

• DANGER—TO REDUCE THE RISK OF FIRE OR

ELECTRICAL SHOCK, CAREFULLY FOLLOW THESE

INSTRUCTIONS.

• CAUTION: Keep dry. Do not use extension cords with

this product. Do not operate if it has been subjected to

electrical or physical shock or other damage. Do not

disassemble product.

• This product is not intended for use by persons

(including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge,

unless they have been given supervision or instruction

concerning the use of the product by a person responsible

for their safety.

• Children should be supervised to ensure that they do

not play with the product.

• It is normal for batteries to become warm while

charging.

Support

www.kodak.com/go/support

www.kodak.com/go/contact

Regulatory Information

FCC compliance and advisory
This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2)

this device must accept any interference received,

including interference that may cause undesired operation.
This equipment generates, uses, and can radiate radio

frequency energy and, if not installed or used in accordance

with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee

that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following

measures: (1) reorient or relocate the receiving antenna;

(2) increase the separation between the equipment and

the receiver; (3) connect the equipment to an outlet on

a circuit different from that to which the receiver is

connected; (4) consult the dealer or an experienced radio/TV

technician for additional suggestions.
Any changes or modiﬁcations not expressly approved by

the party responsible for compliance could void the user’s

authority to operate the equipment. Where shielded

interface cables have been provided with the product or

speciﬁed additional components or accessories elsewhere

deﬁned to be used with the installation of the product,

they must be used in order to ensure compliance with FCC

regulation.
Canadian DOC statement
DOC Class B compliance—This Class B digital apparatus

complies with Canadian ICES-003.
Observation des normes-Class B—Cet appareil

numérique de la classe B est conforme à la norme

NMB-003 du Canada.

Status LED:

Green — charging

Off — charging complete

Eastman Kodak Company

Rochester, NY 14650 U.S.A.