Nilfisk-ALTO E 140.2 User Manual

Page 10

5.2 Typical fi elds of application

Below you will fi nd a description of a lot of cleaning tasks which can be solved by a pressure washer
from Nilfi sk in association with accessories and detergents.

Task

Accessories ‘Click

& Clean’

Cleaning method

Car

Car nozzle,
auto brush,
underchassis

nozzle,

Foam sprayer,

Car Combi Cleaner

1. Apply Car Combi Cleaner with the foam sprayer. Always

start from the bottom and work upwards. Let Car Combi

Cleaner act for at least 5 min.
2. Wash the car with the car nozzle, which has been optimized for

quick and gentle cleaning of enamelled surfaces (the jet is wider
and not so sharp). Start at the front of the car and work back-
wards to avoid water from penetrating by the door mouldings.

3. Use the brush for removal of traffi c fi lm which is not removed by the

nozzle. If the car is very dirty, apply Car Combi Clean er again.

4. Attach the undercarriage nozzle and clean undercarriage and

wheel arches.

5. Remove water from the surface of the car with the scraper

on the car brush. Make sure that all grains of sand etc. have
been removed before using the scraper. Wipe with a wash lea-
ther where the scraper cannot reach.

Rims, alu-

minium

Rim brush,
auto nozzle,
atomizer,
Alu Cleaner

Apply Alu Cleaner with an automizer. Let it act for approx.

5 min. and wash with the rim brush. For steel rims, use Car Com-
bi Cleaner. Use the foam sprayer and wash with rim brush.

Be careful! The high pressure jet may damage the tyres.

Flag-

stones,

concrete

fl oors and
other hard
surfaces

Powerspeed

nozzle,
Stone & Wood
Cleaner,
Patio Cleaner

Wash towards outlets or the like. On surfaces with moss or
algae you may start by applying Stone & Wood Cleaner with
the foam sprayer. Wash before the soap dries. Another
more effective and quicker method is to use the Patio
Cleaner. Thus you will also avoid splashes.

Garden

furniture,
wood

Wood Cleaner
Garden brush

Apply Wood Cleaner and wash before the soap dries.
NOTE: Use the garden brush to clean off the dirt.

Brickwork,
Wood

work

Powerspeed

nozzle,
Stone & Wood
Cleaner,
Patio Cleaner

Same method as for fl agstones, but be careful - bad joints and

wood may be damaged by high pressure. You may choose only
to use the Tornado

nozzle. Adjust the distance (pressure) to

the quality of the joints and the wood. Patio Cleaner can also be
used on vertical surfaces.

Gutter

Underchassis spray

lance

Wash the gutter with the nozzle. Always wash towards

downpipes. Beware not to spray under the roofi ng.

Cleaning

of drain
pipes, out-
lets, down
pipes etc.

Tube cleaner

Push the tube cleaner approx. ½ m (to mark) into a tube or drain

and activate the trigger of the spray handle. The nozzle opening
turning backwards will pull the cleaner through the tube. The
nozzle will break down the „plug“ and fl ush the dirt backwards.

Rust, paint Water/sandblasting

equipment

Mount the water/sand blasting equipment and rust and paint

is effi ciently and quickly removed. Beware not to damage the
surface to be sandblasted.

Green-

house

Tornado

PR nozzle

brush, Stone &

Wood Cleaner

Wash with high pressure and maybe a brush. You may use Stone

& Wood Cleaner to remove moss and algae.

Garden

tools,
lawn
mover

Tornado

nozzle, Power-
speed

nozzle,

multiangle adaptor,
Metal Cleaner

Rinse the worst dirt off with the nozzle. Apply Metal Cleaner with

the foam sprayer and let it act for approx. 5 min. Wash with the
nozzle. You may use the multiangle adaptor for hard to get at
areas to avoid splashing.