Other useful features, Adjusting brightness of picture, Adjusting color density of picture – Alpine TME-M790 User Manual
Page 10: Adjusting tint of picture
8
-EN
Other Useful Features
SET UP
9
8
/
-
AUX
Adjusting Brightness of Picture
NOTE
After carrying out the steps 1 to 3 of "Viewing the
switching display modes" described on page 6, perform
the operation shown below.
1
Press the SET UP button.
2
Press the
9
or
8
button within 10 seconds and
select BRIGHT.
3
Press the
4
or
3
button within 10 seconds to
adjust the brightness.
4
Press the SET UP button to finish adjustments.
NOTE
If the AUX button is pressed and held for 2 seconds or
more while in the adjustment screen, the setting of the
brightness, color density, and tint is reset back to its
center value.
Adjusting Color Density of Picture
NOTE
After carrying out the steps 1 to 3 of "Viewing the
switching display modes" described on page 6, perform
the operation shown below.
1
Press the SET UP button.
2
Press the
9
or
8
button within 10 seconds and
select COLOR.
SET UP
AUX1
BRIGHT 0
COLOR 0
TINT 0
AUX OUT
LINK
MIN
MAX
1
3
3
Press the
4
or
3
button within 10 seconds to
adjust the color density.
4
Press the SET UP button to finish adjustments.
NOTES
• If the AUX button is pressed and held for 2 seconds
or more while in the adjustment screen, the setting of
the brightness, color density, and tint is reset back to
its center value.
• The color density cannot be adjusted in the
NAVIGATION (RGB connection) mode.
Adjusting Tint of Picture
NOTE
After carrying out the steps 1 to 3 of "Viewing the
switching display modes" described on page 6, perform
the operation shown below.
1
Press the SET UP button.
2
Press the
9
or
8
button within 10 seconds and
select TINT.
3
Press the
4
or
3
button within 10 seconds to
adjust the tint.
4
Press the SET UP button to finish adjustments.
NOTES
• If the AUX button is pressed and held for 2 seconds
or more while in the adjustment screen, the setting of
the brightness, color density, and tint is reset back to
its center value.
• The tint cannot be adjusted in the NAVIGATION
(RGB connection) mode.
SET UP
AUX1
–
+
BRIGHT 0
COLOR 0
TINT 0
AUX OUT
LINK
1
3
SET UP
AUX1
R
G
BRIGHT 0
COLOR 0
TINT 0
AUX OUT
LINK
1
3