Arcam AVR200 User Manual

Page 13

AVR200

English

TAPE MONITOR
The

TAPE MONITOR

button selects the audio output from a

cassette deck connected to the

TAPE IN

phono sockets of the

AVR200. It also enables you to monitor a recording being made
on a 3-head cassette deck. Tape monitor status is shown in red
on the display.

When the tape monitor is selected, pressing other source
buttons changes the signal sent to the recorder.

CD
The

button selects the source connected to the

phono

sockets.

FM, AM
To select the integrated tuner function of the AVR200, press the

button. See the section ‘Using the tuner’.

VOLUME control
To adjust the volume level of the loudspeakers, pre-amp outputs
and headphones use the

VOLUME

control. The volume level is

shown in the display while it is being adjusted. Three seconds
after the volume is adjusted, the display reverts to show the
selected input.

Note that different sources may require different settings of the

VOLUME

control to achieve the same perceived volume level.

The volume can be controlled from 0dB over 80 steps.

BASS and TREBLE controls
Turn the bass and treble controls clockwise to boost response
or anticlockwise to cut response. For a fl at response leave the
controls in the 12 o’clock ‘notched’ position.

Pressing the

DIRECT

button bypasses the bass and treble

controls and gives a small improvement to sound quality. If
you do not wish to alter the bass or treble controls, we
recommended that you select

DIRECT

after 3 seconds

DOLBY PL II

SPEAKERS

VIDEO 1

MUSIC

DOLBY PL II

SPEAKERS

VIDEO 1

MUSIC

NOTE:

TAPE MONITOR

is a latching button: you will need to

press it again before selecting another source for listening.