Pft8855 – Vogels PFT 8855 User Manual

Page 4

www.vogels.com

9531-060-001-00

Installation Guide

Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids

PFT8855

4mm

5mm

Two people recommended for this portion of the “mega” cart
assembly process. Raise the receiver cross bar assembly
to the desired “centerline” height and secure to the uprights
firmly with the four “button head Allen screws and flat wash-
ers supplied.

The 90 degree rotation stop can be installed to allow for left
or right rotation of the arm only. Simply remove the two M6
flat head screw to reposition the 90 degree stop plate and
reinstall

With the rear of the lower pan exposed now would be the
time to place and wire any powered support products feed-
ing the display with the power and signal cable being fed
between the front and rear upper cover panels. Power and
signal cable can also be run up through the three rubber
grommet hole in the base ob the pan as well.
Once housed the rear cover panel may now be installed
with the four “button head” Allen screws supplied. Access to
the inner pan is still available through the rear oval access
cover.

Install the lower front panel cover to the frame front and
secure to the frame assembly with the four each M6 x 1.0 x
10mm “button head” Allen head screws supplied