Cyborg V.5 Keyboard - Manual (Page 2)

2
Installing your new Cyborg ® V.5 keyboard
Introduction
The Cyborg ® V.5 keyboard is a Classic 104 key QWERTY layout featuring a host of technology enhancements that
enable the use of the keyboard in not just low-light conditions, but total darkness. The Cyborg ® V.5 keyboard
features TruVu keys that allow the ultra blue lighting to glow through each laser-etched key - making it possible to
read the keys in the dark.
Features:
• 104 key keyboard
• Designed for applications where low light conditions prevent accurate use of a normal keyboard
• Solid, weighted base with large area rubber feet to keep keyboard securely planted to the desk
• Angle adjustment feet for maximum comfort and increased productivity
• Volume buttons and Bright / Dim / Off selector to control blue LED backlighting
Installation for users of Windows ® XP, XP64, Vista and 7 (all
versions)
A) Drivers Only
With your computer switched on, close down any programs that are currently running and insert the Installation CD
into your CD-ROM drive.
When the Introduction Screen appears, click Install Software to continue. If the C D does not run automatically,
select Start from the Windows® Taskbar, then Run and type D:\Setup.exe and click OK - where D:\ is letter of your
CD-ROM drive. For Vista/7 users, the screen will ask Do you want to run this file? Press Run. A screen will now
appear saying A program needs your permission to continue. Press Continue.
When the Welcome screen appears, click Next to continue.
After reading the Disclaimer, select the I accept the terms of the Disclaimer option and click Next to continue.
At the Registration screen, select Check this box to register now and follow the on-screen instructions, or you can
choose to select this option later.
Click on Finish to complete the installation.
B) Drivers and Programming Software
Follow points 1 - 6 of the install procedure in A), then at the Software Setup screen, select Install the Cyborg
® ST
Programming Software and click Next. For Vista/ 7 users, the screen will once again ask Do you want to run this
file? Press Run. A screen will now appear saying A program needs your permission to continue. Press Continue.
In the following Software Setup screen, click Next and follow the on-screen instructions. At this point Vista/7 users