Silent Call CR30 - Manual (Page 3)

Revision 1
5095 Williams Lake Road, Waterford Michigan 48329
(800) 572-5227 (Voice / TTY)
4. While the CR30 lamp is flashing, press the button on a transmitter to send a signal.
The CR30 crystal lamp will go out, indicating that it has received and remembered the
code of the transmitter. Wait five seconds and the CR30 is ready for use. Test by
pressing the button on any transmitter. Once learned, all codes remain in memory even
if power is removed.
5. The CR30 only has to be programmed with one transmitter as long as all of your
transmitters are set to the same code . It will respond to an unlimited number of
transmitters on the same code. The CR30 can also learn up to eight different codes
for large installations where it is desirable to have transmitters set to different
codes.
Erasing all learned transmitters
To erase all codes learned by the CR30, unplug the power supply from the CR30. Then
press and hold the lamp test / program button and plug the power supply back in while
holding the lamp test / program button. When the LEDs illuminate, release the button.
The CR30 memory is now cleared. Re-learn any transmitters as desired.
Specifications
Power: 120VAC, 20VA from supplied wall mounted power supply
Lamp: 12V, 20W bi-pin tungsten halogen (available from Silent Call)
Direct telephone input: Modular telephone receptacle
Vibrator output:
12V, for Silent Call VIB-PJ vibrator (optional)
Range: Up to 100 feet, depending on conditions
Warranty
Your CR30 receiver (excluding the lamp) is warranted to be free of defects in material and
workmanship for five years from the date of initial purchase. During that time, the unit
will be repaired or replaced free of charge when shipped prepaid to Silent Call
Communications. To obtain warranty service, contact Silent Call to obtain a return
materials authorization. This warranty is void if the defect is caused by customer abuse
or neglect.