Silent Call WCV08-SS - Manual (Page 2)

4. Turn charger on by sliding the ON/OFF SWITCH on top of the Charger/Docking Station to the “ON” position.
The watch display will show the time 11:59 am. The charging indicator light, on the right side of the docking
station, will illuminate. The red LED (light) indicates that the AC power is on and the watch is charging. A blue
LED (light) indicates that the watch is fully charged.
5. Your “Silent Touch” Watch Receiver is now ready to use.
6. Remove the “Silent Touch” Watch from the charger by pushing down gently on the release button to the left
of the watch.
Battery:
Your “Silent Touch” Watch Receiver comes with a special battery that has already been installed at the factory. When
the lifespan of the battery has been depleted, you MUST return the “Silent Touch” Watch to our factory for battery
replacement. It is not possible for you to replace the battery on your own and if attempted you will void your
warranty and possibly damage the receiver. Please note that batteries are not warranted and you will be charged the
current rate for the battery at that time.
Set Clock Time:
1. Press and hold the SW3 button.
2. Press and release the SW1 button to set the minutes. Press and release the SW2 button to set the hour.
3. When you are finished setting the minutes and hours, release the SW3 button
.
Note: Any time the charge has been completely depleted on you “Silent Touch” Watch, you will need to reset
the clock and alarm time. To avoid having to do this, be sure to charge your “Silent Touch” Watch every night.
The watch will charge in approximately twenty minutes and is designed to stay on charge for extended periods
of time without causing any damage.
Setting Alarm Clock:
1. Press and hold the SW1 button. The bell Icon will come on and the time will begin to flash indicating that you
are in “SET UP” mode.
2. The display will show the present Alarm Clock Time setting.
3. While still holding down the SW1 button, press and release the SW2 button to set minutes and press and
release the SW3 button to set the hours.
4. Once the Alarm Clock Time has been set, release the SW1 button to exit the “SET UP” mode.
5. To turn the alarm clock On or Off, push and release the SW1.
6. When the alarm is activated the bell icon will flash and the bed vibrator will shake.
7. To cancel the ALARM alert when you are wearing the watch, press and release the SW 2 button. . While the
watch is in the charger pressing the recall button on top of the charger will cancel the alarm clock alert.
Indicator Light
Watch Release Button
Recall Button
Power On/Off Switch
Power Supply Input Jack Vibrator Input Jack
Battery Backup On/Off Switch
SW1 button
Erase Button