Pfannenberg PYRA PY X-M Series - Manual (Page 5)

085 501 972 30360-004 5
Approvals
Approvals (valid for marked equipment)
Construction Product
Directive
(89/106/EW G)
(in preparation)
PY X-M-05 + PY X-M-10: VdS 0786-CPD-xxxx
Rated voltage
12V DC 24V DC 48V DC
Operating voltage range acc. to EN54-23 10V – 60V DC
Lens colours red, clear
Signalling area EN 54-23 Category O: see document 30360-005-1
Environmental
protection class
Type B
Installation position see document 30360-005-1
Testing takes place using the supplied diaphragm nipple and the outer fastening bores.
VdS
in preparation
PY X-M-05 + PY X-M-10: G212xxx, data see Construction Product Directive (89/106/EW G)
UL, cUL
in preparation
PY X-M-xx + PY X-MA-xx
Rated Voltage Visual Signal Appliance - General Signaling Equipment - UEES, UEES7
115V AC
230V AC
24V AC/ DC Suitable for indoor and outdoor use.
W arning: Not to be used as a Visual Public Mode Alarm Notification Appliance.
According to CSA-C22.2 No. 205-M1983 clause 4.3.4 the connection is limited to max. three
leads.
PYRA Xenon beacons PY X-M(A)-xx comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Taking into Operation
Safety notes:
- Installation must be carried out by an electrician in compliance with the latest codes and regulations.
- Danger: High voltage may be present.
- Prior to opening, it must be ensured that no voltage is applied to the device.
- Before electrical connection, the supply voltage on the type plate is to be checked. The wrong operating voltage can lead to
damages or to the destruction of the equipment.
- During installation it must be ensured that the connection cables are secured against tension and distortion.
Please observe: The devices are not designed for portable use.
- CAUTION: When making installation, route field wiring away from sharp projections, corners and internal components.
- The function of the unit is only guaranteed if the upper and lower section is joined correctly.
- In order to prevent detriment to sight, continuously looking directly in the activated light is to be avoided.
Opening the housing Closing the housing
3/8
1. 2.
3/8
1. 2.
The unit is not closed when delivered. Sealing plugs for the housing screws are available as accessories.
Electrical connection:
Connecting cables
The beacons satisfy the requirements of the standard EN54-23 (Synchronization).
Caution: In order to ensure synchronization, the devices must be operated with the same potential..
PY X-M-xx
7 [0.28"]
solid
7 [0.28"]
stranded
Connection for
operation voltage
By loosing the four
cover screws, the upper
section can be
removed.
The housing is closed by
turning the cover screws to
the limit position until the
housing locks into place
.
S1,
Tone Selector Switch
Volume
Control
Operation voltage for
sounder
Operation voltage
for beacon
PY X-MA-xx