beautypg.com

Troubleshooting, Warning, Changing the light bulbs – Amana W10211609A User Manual

Page 13: Refrigerator operation

background image

13

Changing the Light Bulbs

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to
replace the bulb with one of the same size, shape, and wattage.

Refrigerator Light

1. Unplug refrigerator or disconnect power.
2. Reach behind the control panel and unscrew the bulb.
3. Replace the bulb with a 40-watt appliance bulb.
4. Plug in refrigerator or reconnect power.

Freezer Light

1. Unplug refrigerator or disconnect power.
2. Remove the freezer shelf.
3. Remove the freezer light shield by pushing down.

4. Remove the light bulb and replace with one of the same size,

shape and wattage.

5. Replace the light shield.

6. Plug in refrigerator or reconnect power.

TROUBLESHOOTING

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service call.

In the U.S.A., www.amana.com In Canada, www.amanacanada.ca

Refrigerator Operation

The refrigerator will not operate

Power cord unplugged? Plug into a grounded 3 prong outlet.

Is outlet working? Plug in a lamp to see if the outlet is
working.

Household fuse blown or circuit breaker tripped? Replace
the fuse or reset the circuit breaker. If the problem continues,
call an electrician.

Control(s) on? Make sure the refrigerator control is on. See
“Using the Control(s).”

New installation? Allow 24 hours following installation for the
refrigerator to cool completely.

NOTE: Adjusting the temperature control(s) to coldest setting
will not cool the refrigerator more quickly.

The motor seems to run too much

Your new refrigerator may run longer than your old one due to its
high-efficiency compressor and fans. The unit may run even
longer if the room is warm, a large food load is added, the door is
opened often, or if the door has been left open.

The refrigerator seems noisy

Refrigerator noise has been reduced over the years. Due to this
reduction, you may hear intermittent noises from your new
refrigerator that you did not notice from your old model. Below are
listed some normal sounds with explanations.

Pulsating - fans/compressor adjusting to optimize
performance.

Hissing/Rattling - flow of refrigerant, movement of water
lines, or from items placed on top of the refrigerator.

Popping - contraction/expansion of inside walls, especially
during initial cool-down.

Water running/dripping - may be heard when ice melts
during defrosting and water runs into the drain pan.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

This manual is related to the following products: