Tap tower installation, En g li s h – Nostalgia Electrics KRS2100 SERIES User Manual

Page 12

& TAP TOWER INSTALLATION

You must read and understand the steps below for the CO2 assembly before installation.

When you purchase the first keg of beer, you must also have your CO2 cylinder filled at

your local supplier. CO2 tanks can be refilled at locations such as welding supply shops,

party stores, or wherever kegs are purchased.

(cont. on next page)

STEP 1

Make sure white nylon High Pressure

Washer (already installed) is attached

to CO2 Double Regulator.

STEP 2

Use Wrench to attach Double

Regulator to CO2 Tank connector.

STEP 3

Remove spring from inside the Keg Coupler.

If spring is not present, go on to Step 4.

STEP 4

Make sure Backflow Stopper is inserted

in the Keg Coupler (the Backflow Stopper

goes in with rounded side down).

STEP 5

After the Backflow Stopper has been

inserted, remove the three parts above.