Nostalgia Electrics FFT100 - Manual (Page 8)

E
N
G
LI
S
H
6
ASSEMBLY
1.
Insert the Grinder into the Chute.
2. Be sure the gasket is properly placed inside the Dispenser. Then, screw the Dispenser to the
Chute by placing on the front and turning counterclockwise until the opening faces down.
3. Insert the tip of the Grinder into the Base of the unit. Turn counterclockwise to lock
the Chute assembly in place. Make sure the Chute, Grinder and Dispenser are properly
assembled and affixed to the Base.
4. Place the Chute Cover over the Chute assembly.
5. Insert the Plunger into the Chute and place the Drip Tray
under the Dispenser at the bottom of the Base.