Nostalgia Electrics SCC200 - Manual (Page 10)

ENGLISH
8
Assembly of Wheels
Insert Axle Bolt (F) into Base Support (I). 1.
Put on #5 Flat Washer. Slide Wheel (G) onto Axle Bolt (F), then 2.
add a second #5 Flat Washer and #6 Nut Cap.
Use Wrench (H) to tighten the #6 Nut Cap. 3.
On the other side of Base Support (I), insert second Axel Bolt (F), add #5 4.
Flat Washer, second Wheel (G), another #5 Flat Washer, and a #6 Nut Cap.
Use Wrench (H) to tighten the #6 Nut Cap. 5.
Locking Main Unit to Storage Compartment
Place the Main Unit (A) onto the Storage Compartment (B) so that the two
side holes match up. Lock by tightening the Lock Screws as shown below:
PDF
!"#
"pdfFactory Pro"
$#%&'(
www.fineprint.cn
(#6)
Nut
Cap
(#5)
Flat
Washer
(F)
Axle
Bolt
(G)
Wheel
(I)
Base
Support