Nostalgia Electrics ISM800 - Manual (Page 8)

E
N
G
LI
S
H
6
HOW TO OPERATE
• Fill a standard ice cube tray or the supplied Ice Molds with water
and place in freezer until frozen. Remove ice from tray(s). See
HELPFUL TIPS section for instructions on using Ice Molds.
• Place the SHAVED ICE MACHINE on a stable, waterproof
surface near an electrical outlet before starting.
• Always make sure that the cord is away from a water source.
• With Shaver Bowl placed on top of Base, place frozen ice cubes in Shaver Bowl.
If using ice from Ice Molds, place with flat side down and notched side up.
• BE CAREFUL when placing ice cubes in Shaver Bowl. The blade in the Shaver Bowl is
very sharp.
• Place a bowl under the Shaver Bowl to catch the shaved ice.
• Place the Motor Cabinet on top of the Shaver Bowl and hold in place. When filled with
ice, the Motor Cabinet will rest a few inches above the bottom of the Shaver Bowl.
• Plug in the unit. The SHAVED ICE MACHINE operates at one speed. While holding the Motor
Cabinet steady with one hand, press the Power Button. It will start with a gentle press.
• Press continuously until majority of ice is shaved, or until the Motor Cabinet sits flush on
the bottom of the Ice Bowl. To stop shaving ice, release pressure on the Power Button.
• Some ice may remain in the Shaver Bowl. Discard this ice before adding a new ice cube.
• Repeat the process until you have the desired amount of shaved ice.
• After each 1 minute of continuous use, wait 10 minutes
before using again to allow motor to cool.
• Unplug unit from outlet when finished.
HELPFUL TIPS
USING ICE MOLDS
Common ice cubes may be used in the SHAVED ICE MACHINE, but will produce slightly
coarser textured ice. For best results, we recommend using the included Ice Molds.
• Fill the supplied Ice Molds with liquid to approximately
½ inch below the top, just below the Max fill line.
• Place on a flat surface in the freezer until frozen (about 10 - 12 hours).
• If unable to remove ice from Ice Molds, run under water until ice is loose.
• Each Ice Mold makes approximately 2 cups of shaved ice.
• Ice Molds may also be used as serving bowls for shaved ice.
USING TRADITIONAL ICE CUBES
• Place 10 medium-sized ice cubes in an even layer in Shaver
Bowl to yield approximately 2 cups of shaved ice.
• Do not overfill Shaver Bowl with ice.