Boot -13, Chapter 3, Boot – MSI X99S MPOWER Manual User Manual
Page 79
Chapter 3
3-12
BIOS Setup
3-13
BIOS Setup
▶Resume By PCI-E Device [Disabled]
Disables or enables the system wake up by PCI express device.
[Enabled]
Enables the system to be awakened from the power saving modes
when activity or input signal of PCIe device is detected. Note:
enables this Item to support “Resume from S3 by USB Device” with
third party USB 3.0 port.
[Disabled]
Disables this function.
▶Resume by USB Device [Disabled]
Disables or enables the system wake up by USB devices.
[Enabled]
Enables the system to be awakened from sleep state when activity
of USB device is detected.
[Disabled]
Disables this function.
▶Resume From S3/S4/S5 by PS/2 Mouse [Disabled]
Disables or enables the system wake up by PS/2 mouse.
[Enabled]
Enables the system to be awakened from S3/ S4/ S5 state when
activity of PS/2 mouse is detected.
[Disabled]
Disables this function.
▶Resume From S3/S4/S5 by PS/2 Keyboard [Disabled]
Disables or enables the system wake up by PS/2 keyboard.
[Any Key]
Enables the system to be awakened from S3/ S4/ S5 state when
activity of any key on PS/2 keyboard is detected.
[Hot Key]
Enables the system to be awakened from S3/ S4/ S5 state when
activity of hot key on PS/2 keyboard is detected.
[Disabled]
Disables this function.
Boot
Sets the sequence of system boot devices.
▶Full Screen Logo Display [Enabled]
Enables or disables to show the full screen logo while system POST.
[Enabled]
The OS boots straight to the GUI without showing the POST screen.
[Disabled]
Shows the POST messages at booting.
▶GO2BIOS [Disabled]
Enables or disables the system to power on and go to the BIOS setup directly by long
pressing the power button about 4 seconds when the system is off.
[Enabled]
The system boots straight to the BIOS setup by long pressing the power
button about 2~4 seconds when the system is off.
[Disabled]
Disables this function.
▶Boot Mode Select [LEGACY+UEFI]
Sets the system boot mode from legacy or UEFI architecture depending on OS
installation requirement. This item will become unselectable and will be configured
automatically by BIOS when “Windows 8/ 8.1 Feature” is enabled.
[UEFI]
Enables UEFI BIOS boot mode support only.
[LEGACY+UEFI] Enables both Legacy BIOS boot mode and UEFI BIOS boot
mode.