Asus 810E - Manual (Page 37)

ASUS CUWE User’s Manual 37
3. HARDWARE SETUP
Connectors
3. H/W SETUP
16) Internal Audio Connectors (4-pin VIDEO, AUX, CD, TAD)
These connectors allow you to receive stereo audio input from such sound sources
as a CD-ROM, TV tuner, or MPEG card. The TAD connector allows the on-
board audio to interface with a voice modem card with a similar connector. It
also allows the sharing of mono_in (such as a phone) and mono_out (such as a
speaker) between the onboard audio and the voice modem card.
01 01 01
®
CUWE
CUWE Internal Audio Connectors
TAD In/Out
Modem-Out (from Modem)
Ground
Modem-In (to Modem)
CD In (Black)
Right Audio Channel
Left Audio Channel
Ground
AUX In (White)
Right Audio Channel
Left Audio Channel
Ground
VIDEO In (Green)
Right Audio Channel
Left Audio Channel
Ground
17) Internal Speaker Connector (SPKEAR)
This connector allows you to connect the internal chassis speaker to the onboard
audio’s output. This will allow you to use the chassis’ built-in speaker to listen to
sounds normally requiring separately purchased external speakers. The ground
(GND) wire is usually the black wire and the speaker-out (SPKOUT) is usually
the red wire. System beeps and warnings sent through the chassis speaker con-
nector is also routed through this internal speaker connector so that there is no
need for two speakers.
01 01 01
®
CUWE
CUWE Internal Speaker Connector
SPKEAR
SPKOUT
GND
1
4