Next Advance 50-AU - Manual (Page 5)

5
Operator’s Manual for the Bullet Blender ® 50
[email protected]. Do not
touch or tamper with the electronics.
TROUBLESHOOTING
In addition to the tips given below, a
thorough list of troubleshooting tips is at
http://www.nextadvance.com/FAQs/FAQ
s-Bullet_Blender.htm.
If the Bullet Blender doesn’t start,
make sure the Power Switch is in the ON
(I) position. Make sure that the sample
plate lid is in the “locked” position. The
plug of the power supply cord might not
be in a live wall outlet or the power
supply connector might not be fully
inserted in the AC Input Receptacle of the
Bullet Blender
® 50.
If the unit stops working, turn the
system off for 15 minutes to allow the
electronics to reset. If the Bullet Blender
®
50 does not turn on after this period,
contact customer service.
If the caps on the 50 mL tubes
loosen, make sure that the screw threads
between the lids and the caps are dry
when you close the caps or screw them
on, so that there is enough friction for the
caps to remain tight. Using recommended
types of tubes will minimize cap failure.
For best results, the tubes and sleeves
should be evenly spaced when placed in
the Bullet Blender.
If the 4°C light is not coming on,
frost from condensation may be blocking
the air passage. Remove the inner dry ice
compartment and gently agitate it or replace
the ice. If mist coming out of the dry ice
cooling container seems excessive, make
sure that the lid of the dry ice container is
closed securely
SUPPORT
FAQs, protocols, and other helpful informa-
tion are available on our website,
http://www.nextadvance.com. Click on the
Bullet Blender, then on the appropriate link.
If you cannot find an answer there, please
contact customer service by email at
[email protected] or by
telephone at (518) 674-3510 or (800)
738-1681.
SPECIFICATIONS
Size: BB50-DX is 35 cm (14 in.) deep x 38
cm (15 in.) wide x 38 cm (15 in.) high.
BB5050-AU is 35 cm (14 in.) deep x 46 cm
(18 in.) wide x 38 cm (15 in.) high.
Weight: 33lbs (15 kg)
Power Requirement: 100-240 V, 50-60 Hz,
2.5-4.5 A
Capacity: 8 of 50 mL skirted (self-standing)
polypropylene tubes.
Relative Humidity: 5 - 90% non-condensing
Operating Temperature: 4 - 40°C
Altitude: <2000m
Storage Temperature: -40 to 50°C
Meets requirements (-CE models only)
clean the outside of the unit only with mild
detergent, water and a soft cloth. Under
normal conditions, the Bullet Blender
® 50
should never need to be disassembled for
cleaning. In the case of a large spill, please
contact Next Advance at