Kramer Electronics RB-8 User Manual
Page 8
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the RB-8/RB-8E
6
6
Connecting the RB-8/RB-8E
To connect the
RB-8/RB-8E, as illustrated in Figure 4, do the following:
1. Connect the power cable from each external device to any free power output
port on the
RB-8/RB-8E.
2. Connect a switched cable to the CONTROL/GROUND contact of the same
port (for example, from the
PL-8 Low Voltage Relay Controller as shown in
Figure 2.)
3. Connect the power cord to the
RB-8/RB-8E (not illustrated in Figure 2.)
Figure 4: Connecting the RB-8